 Solidity and reliability 
The centrifugal monobloc range CMO, has been designed in order to obtain the best performances with a reduced cost. Easy to handle, the pumps of this range are strong, compact construction, produced in their components with high thickness to give a product with the maximum reliability. Suitable to transfer acid and basic solutions, the wet ends, are produced in thermoplastics (PP-PVDF) and O-ring in the proper elastomer material (EPDM-FPM-FEP). Different mechanical seal solutions are available: from the lip seal to primary label seals (internal, external and double flushed) in standard version with faces in Silicon Carbide (SIC-SIC) and bellow elastomer (FPMEPDM).
The impellers installed are generally semi-open, but they are available in the closed version for hot liquids and without solids in suspension.
Exercise temperatures and materials
MATERIALS SELECTION
The materials used in the production of our pumps, are carefully selected based upon the pumped liquids. Each material used must answer at mechanical and chemical characteristics in order to grant the best reliability of the pump. The working temperature is a really important condition, especially because the thermoplastics are materials very sensible to low and high temperatures.
Performances
PUMPS SELECTION
Pumps are selected based on the data transmitted from the Customer. Capacity Q, head H, specific gravity and liquid viscosity,temperature, N.P.S.H. available in the plant are required in order to proceed to the correct pump choice. The choosed pump has to work close to the best efficency point of the curve in order to obtain a reduced energy consumption and to avoid abnormal hydrodynamic situations (cavitations,turbulences, etc.)
CURVES
.gif)
RPM 2900 50Hz
|
.gif)
RPM 1450 50Hz
|
.gif)
RPM 3450 60Hz
|
.gif)
RPM 1750 60Hz
|
|
.gif)
.gif)
.gif)
.gif)
